![]() ![]() You might think PVC is not sturdy enough to make a durable blind frame, but Orth said he has only experienced two problems. To remove the blind after the hunting season, Orth simply uses a power drill to remove the screws holding the conduit clamps to the seats. The entire blind is so light two hunters have no trouble putting it on or taking it off the boat. "I also made a top that fits about half-way across the boat to help hide the hunters," he said. The clamps allow the PVC pipe frames to rotate freely so he can quickly collapse or erect the blind. Then he attached the bottoms of the side frames to the aluminum boat seats using metal conduit clamps and self-tapping screws. Using aerosol paints specifically formulated for use on plastics, he painted the framework. When I am setting up the blind at the ramp, I fit the lateral support braces back into the tees." "I slip the three lateral support braces out of the tees and put them in the boat. "When I fold the blind down, the two sides rest on the seats," he said. Once he had assembled both the port and starboard side frames, he glued everything together with the exception of the lateral braces that fit into the inward-facing tees. ![]() On the bow, stern, and rear upright sections, inline tees are located near the tops and face the interior of the boat. "The blind is so easy to set up every hunt from it is nothing but fun." ![]() It has four upright sections on the port and starboard sides that are attached to bottom and top rails with tee fittings for the two central uprights with 90-degree bends on the ends. The framework is essentially a rectangular box. He assembled the blind frame inside the boat, measuring each section of pipe and cutting it with a table saw. Right now, I have two boat blinds, but I am going to build a third one because they have been so successful." We shoot cans, bluebills, redheads, buffleheads and others. "But, we also get lots of mallards, especially early. "We have a lot of deep water, so we get plenty of diving ducks," Orth said. Now 36, he continues to hunt an area of Lake St. Orth, who took third in the 2015 B&B contest, lives near Detroit and has been hunting waterfowl since he was 14 years old. His boat blind frame is made of 2" PVC pipe, making it lightweight, inexpensive, rustproof and easy to build with simple tools. When the weather turns, it can pose some extraordinarily harsh conditions, but Orth hunts a shoreline that blocks the wind and public boating access is close by, so it's not as risky as making long runs on open water. A staffing recruiter and outfitter from Michigan, he runs clients on the 430-square mile lake mostly during weekends. Jim Orth needed a simple blind for hunting Lake St. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |